Ford SC-1/Fontana Engine

Frank Reiner · 3/22/23, 7:53 PM

Ford SC-1/Fontana Engine - $16,700
Dyno time only since rebuild

Block—

Align bored, mains & cam tunnel
Rear main thrust surfaces cut square with main bores
Cam bearings installed
Sleeves re-sealed
Top of block decked parallel to mains

Rotating assembly—

Crank magnafluxed, renitrided, polished
New Dyer 300M rods
New CP pistons

Valve train—

New cam billet, Bob Wirth profiles, ground by Bullet
New Crower lifters
New T&D rockers
Ti valves, PSI springs

Kinsler injection
EFI ignition
Barnes oil pump
New K&N air filter
New Schoenfeld exhaust

3/22/23, 7:53 PM	#1 Ford SC-1/Fontana Engine
Frank Reiner Member Join Date: Oct 2013 Posts: 108	Ford SC-1/Fontana Engine - $16,700 Dyno time only since rebuild Block— Align bored, mains & cam tunnel Rear main thrust surfaces cut square with main bores Cam bearings installed Sleeves re-sealed Top of block decked parallel to mains Rotating assembly— Crank magnafluxed, renitrided, polished New Dyer 300M rods New CP pistons Valve train— New cam billet, Bob Wirth profiles, ground by Bullet New Crower lifters New T&D rockers Ti valves, PSI springs Kinsler injection EFI ignition Barnes oil pump New K&N air filter New Schoenfeld exhaust